The "PropertiesChanged" signal

PropertiesChanged (a{sv} properties);

DEPRECATED. Use the standard "PropertiesChanged" signal from "org.freedesktop.DBus.Properties" instead which exists since version NetworkManager 1.2.0.

The "Flags" property

Flags  readable   u

Flags describing the capabilities of the access point.

Returns: NM80211ApFlags

The "WpaFlags" property

WpaFlags  readable   u

Flags describing the access point's capabilities according to WPA (Wifi Protected Access).

Returns: NM80211ApSecurityFlags

The "RsnFlags" property

RsnFlags  readable   u

Flags describing the access point's capabilities according to the RSN (Robust Secure Network) protocol.

Returns: NM80211ApSecurityFlags

The "Ssid" property

Ssid  readable   ay

The Service Set Identifier identifying the access point.

The "Frequency" property

Frequency  readable   u

The radio channel frequency in use by the access point, in MHz.

The "HwAddress" property

HwAddress  readable   s

The hardware address (BSSID) of the access point.

The "Mode" property

Mode  readable   u

Describes the operating mode of the access point.

Returns: NM80211Mode

The "MaxBitrate" property

MaxBitrate  readable   u

The maximum bitrate this access point is capable of, in kilobits/second (Kb/s).

The "Strength" property

Strength  readable   y

The current signal quality of the access point, in percent.

The "LastSeen" property

LastSeen  readable   i

The timestamp (in CLOCK_BOOTTIME seconds) for the last time the access point was found in scan results. A value of -1 means the access point has never been found in scan results.